Matters needing attention in operation and daily maintenance of continuous sealing machine-Yongchun automatic sealing machine

Matters needing attention in operation and daily maintenance of continuous sealing machine-Yongchun automatic sealing machine

In the packaging of food industry, some products need vacuum, and some products only need sealing. Although the sealing machine looks simple to operate, many customers still can't operate it. Here are some operational precautions and daily maintenance-Yongchun automatic sealing machine.

When the package containing articles is placed on the conveyor belt, the sealing part of the bag is automatically sent between the two running sealing belts and brought into the heating zone. The heat of the heating block is transferred to the sealing part of the bag through the sealing belts, so that the film is heated and melted, and then passes through the cooling zone, so that the surface temperature of the film is appropriately reduced. Then, it is rolled by a Hua Lun (or a printing wheel) to bond the upper and lower plastic films on the sealing part and press out a net pattern (or print a logo). Then, the rubber belt and the conveyor belt will seal the film.

First, the process operation method

1. Press the "ON" button, the power indicator light and "COOLER" (cooling indicator light) will light up, and the warning light will flash.

2. Press the "START" button, the warning light will go out, the "Start" indicator light will be on, and the power will achieve the preset setting.

3. Turn on the power supply of the conveyor belt, run the conveyor belt, and adjust the speed knob to a proper position.

4. Push in the container to be sealed and start normal operation.

5. If overcurrent occurs during operation, the "FAULT" light on the control panel lights up and the warning light flashes. Press the "RESET" button at this time, and then press the "START" button again after the overcurrent light goes out. -Yongchun automatic sealing machine

6. When the work is finished, press the "STOP" key, and the machine will return to the 1 state.

7. Press the "OFF" key to turn off the machine and exit the standby state.

Second, the operation process matters needing attention and daily maintenance

1. This machine uses 220V single-phase three-wire power supply, so the grounding must be reliable, otherwise personal safety will be affected.

2. Metal parts should not be close to the induction head.

3, often check the cooling water level, general frequent use, check once a week, and add cooling water. Better use non-conductive cooling water.

4, often check the pipeline, joint can't have water leakage, water seepage phenomenon. In order to prevent the pipeline from freezing due to low temperature, antifreeze should be injected into the water tank.

5, maintenance should follow the operating sequence. -Yongchun automatic sealing machine

6, maintenance should be fixed professionals.

7, after the boot is not allowed to open the chassis, inspection and maintenance must cut off the total power supply.